Vilaterm Joints

Sealing joints interpanel There are certain technologies eliminate problems associated with the violation of the sealing panel joints of buildings and freezing of joints at the junction of the panels. Specialists institutions sealing developed technology of repair insulation on the joints of panels and restoration sealing "Warm seam, which has already proved its effectiveness when used in Novosibirsk and in many other cities. Using technology "Warm seam" refers to the mandatory application materials: sealants Makrofleks, vozduhozaschitny Vilaterm material and polymer sealant Oksiplast. Main stages of repair joints: 1. Preliminary preparation of joints. 2. Restoration of the surface at the joints.

3. Establishment of additional insulating components. See more detailed opinions by reading what Costco offers on the topic.. 4. Thermal insulation and sealing joints. During the preparatory work the joints between panels cleaned of mud and old paint, embroider a crack in the pits and remove the old sealant. Work on clearing the interface manually, using a hatchet, a hammer, an iron brush, drill. Before sealing joints necessary that the edges of the joint surface was dry. The process of thermal insulation and sealing of exterior joints in houses on the technology "Warm seam" is performed by sealing gaskets Vilaterm.

There are several embodiment of the exterior repair work to seal the joints of the walls (plates, panels), depending on the nature of the breach of joint: sealing open joints, followed by their "closure"; sealed with completing curing mastic, surface sealing. After preliminary training, establish a joint gaskets Vilaterm the entire length of the repair joint. Since they are elastic, they must first be compressed to 25-50% of the cross-section gaskets. After you install the insulation to fill joint penogermetikom. This is done from the outside plates, using aerosol, and special terminals. for knowledge. If the butt is wide, you may need to pass a few times. All repair work must be carried out under conditions of no colder than 15 degrees Celsius or warmer than 35 degrees. After that the seam covers one- or two-component putty that serves as an additional means of sealing and closing penogermetik from the damaging effects of sunlight. Previously, instead of the mastic used Cement basis, but he does not have enough elasticity and eventually crumble with seasonal changes in joint width. This led to what turned out to be a seam open, especially in new buildings. In addition, the solution does not additional sealing effect. Sealing joints interpanel professionals llc Promalpservis "is performed in strict accordance with the technology